Comments
-
@Ajishlal Thank you sir.After your reply I have done first two steps and cpu utilization is dropped little bit in 60 minutes time frame but in 1 hr it showing 100% continuosly.All other option will check soon. Also I m observing that the Core 5,6,7 having more utilization than other.
-
@BWC X0 is our internal network but we have not tried to unplug X0 during this.Need to check this during downtime.As in our network we have enabled RSTP on switches. Also from the TSR report it shows CPU utilization is 100% from past 15 days.
-
Thank you so much @Ajishlal. I will try this and let you know. I was also trying the same way but I was facing problem. I also took help from sonicwall technical support but they said it will not possible with app control.
-
Ok thanks. Will check that.
-
Yes. I am Sonicwall admin and this issue gets frequently and I have read about this that this error occurred because of some firewall rules or some network issues.
-
Thank you. I have done this configuration and it works.
-
I will check it.Thank u.
-
Found the issue with the help of Ping Plotter. Thank u.
-
I have MPLS set up terminate at my L3 and I am pinging to application server present at Head office and I am getting packet lost around 0.3% frequently.Also I have checked the bandwidth utilisation reports.So there is no bandwidth issue.
-
Yes. You are right .but a I recently created subnet and only a single device connected to that interface or VLAN so DHCP should assign IP from 180.4.16.2/21 as 180.4.16.1/21 assign to VLAN interface but it assign 180.4.22.xx/21.
-
Hello My LAN to LAN and LAN to WAN traffic is allowed but not able to ping from X10 to X0.My X0 is in 192.168.1.0/24 subnet and X10 in 192.168.2.0/24 subnet. Both the switch connected are on default VLAN.what am i missing?
-
X0 and X10 are on same zone(LAN) and X0 interface is already configured and accessing WAN so for newly created X10 interface to access WAN is it required to create access rule or it will automatically done through firewall.
-
is it necessary to make X0 interface of firewall as trunk or it automatically handled by SonicWALL firewall. Thanks!
-
Ok.but is it necessary to have same VLAN id on firewall as present on switch & if yes. then I have read the SonicWALL VLAN start from 2 and I have default VLAN 1 on my switch. so how to manage that?
-
Thank you.