Comments
-
Hi @YUBER_SIERRA, The NSa 4700 model supports only Active/Standby HA mode for now.
-
Hi @DLYNCH, I don't think so, this one would be added back. I'm unsure on why did the remove this option. I would suggest you to raise a feature enhancement request with our Sales team to report.
-
Hi @SWUSERVPN, Yes, you can allow/block certain domains using FQDN objects. In simple terms, this can be done using Access Rules. We can get the WAN traffic of the remote sites to go out through the NSA using the central CFS Policies + CFS Profiles. Route All Site to Site VPN has to be configured on both the central and…
-
Hi @PFTS, Please try the suggestions as per below KB articles. Look to see if the firewall runs on its latest firmware version. Hope this helps.
-
Hi @Marco, The document is not handy. But you can search for KB articles pertained to SonicWall products from our KB portal as below, You can also bookmark the KB's as needed for future reference.
-
Hi @MARCO, Thank you for visiting SonicWall Community. I believe the printer is of a wired type and if so, yes, we should be able to add the printer and share it between two IP subnets. You should add the printer on a subnet and allow access to it for the other subnet by allowing the access rules between the zones assigned…
-
Hi @ODANIELSANTIAGO__, We need to check the reason for the tunnel not created on the firewall as it is essential to pass the data over the VPN tunnel to the analytics to display the data. Please seek help from our support team.
-
Glad to hear that the issue is resolved and you are all set @PINALDPS. Have a good one!!!
-
Hi @NEKTON, Sounds to me like an issue on the upstream of the TZ 350. Connect the ISP router directly to the TZ 350 box just to rule out looping at the switch level if any and check the Internet access via TZ 350.
-
Hi @KEVIN_SHRESTHA, Thanks for the device model. Possibly you can try the below KB article steps and see if it helps. Note: I'll be moving this discussion to the appropriate Product Category for better results.
-
Hi @ODANIELSANTIAGO__, Could you please check if there is a VPN tunnel created on the SonicWall firewall appliance? As per your initial screenshot, it looks like the analytics setup fail at "Creating VPN Tunnel". We have to check the logs on the CSC analytics and on the firewall if needed to obtain the root cause.
-
Hi @KEVIN_SHRESTHA, Thank you for visiting SonicWall Community. Could you please let me know if you are looking to disable the alert notification on the SMA or on the Firewall appliance? Please share the alert message once. Thanks and have a good day!!!
-
Hi @VHDURAN, Thank you for visiting SonicWall Community. SonicWave 432O uses four antennas each for the 5 GHz radio and 4 GHz radio respectively. Please use the Getting Started Guide for your reference.
-
Hi @ODANIELSANTIAGO__, Thank you for visiting SonicWall Community. Port UDP 514 is meant for syslogs. Syslogs from Firewall(s) is/are sent to the analytics happens on port UDP 514. Firewall's management setup happens on the web management port.
-
Hi @NEKTON, Thank you for visiting SonicWall Community. During the issue time, please initiate a ping to the SonicWall's WAN gateway from the LAN PC and also from the SonicWall GUI. This would tell if the issue exists between SonicWall and its WAN gateway. Possibly below KB article can help you.