Jour Newbie ✭
- Last Active
Hi @Ajishlal , Thank you for the information provided. Do you also have a switch between ISP modem and SonicWALL's? Just try to figure out if there's a problem in the setup. But it's good to hear that it works for others in Gen 6 with a fail over time of 1-2 min. I am a little bit confused that stateful works in your…
@MasterRoshi , no I didn't. Wasn't aware of this tool. But will be very helpful for the SonicWALLs in the future that we want to migrate from G6 to G7. Thank you for this helpful tip.
@BWC , you are right, they were imported from Gen 6 (NSA2600 Appliance). The problems that you have seen at network routes in the early days of Gen 7, were they also imported of a Gen 6 appliance? Thanks! Joury
Hi @BWC Thank you for your reply. We are running the same firmware version (7.0.1 R5023) as you. When following your steps I am able to create, clone and change the service port of the cloned rule. In that case the two rules are not grouped to each other when I select one of these. When I try to change/edit an existing NAT…
Hey! You will be signed out in 60 seconds due to inactivity. Click here to continue using the site.