Darshil

Newbie ✭
Default Avatar

Howdy, Stranger!

It looks like you're new here. Sign in or register to get started.

Darshil Newbie ✭

About

Username
Darshil
Joined
Visits
276
Last Active
Roles
Partner
Points
30
Badges
5

Badges (5)

1 Year Anniversary5 Likes10 CommentsName DropperFirst Comment

Comments

  • @Larry Right. I want a command to disable capture client through CMD.
  • Hi @Skumar We faced issues with connect tunnel legacy clients where the route was not getting published with proper matrix. It worked properly with the CTDG client version 12.4.1 Can you let us know the difference between the functionalities of the legacy and CTDG clients?
  • This is an SMA 1000 series appliance with the highest no of platforms and client hotfixes. Users are connected VPN through tunnel client.
  • Yes, We require OID to monitor when one link goes down in failover and load balancing.
  • Hi On Packet capture i could only find consumed and generated packets. But somehow the sensor is added on PRTG, now all the interfaces that i have added are fluctuating every few minutes, whereas other firewall sensors like HTTPS, SSL, etc shows green. I also have a cisco L3 switch added on PRTG, it shows no such problems.…
    in SNMP with PRTG Comment by Darshil May 28
  • Hi @Saravanan On Packet capture i could only find consumed and generated packets. But somehow the sensor is added on PRTG, now all the interfaces that i have added are fluctuating every few minutes, whereas other firewall sensors like HTTPS, SSL, etc shows green. I also have a cisco L3 switch added on PRTG, it shows no…
    in SNMP with PRTG Comment by Darshil May 27
  • Hi @Saravanan , I did not find any error logs in the GUI.
    in SNMP with PRTG Comment by Darshil May 25
  • Hi @BWC , I am using SMS OTP inside the radius server. My concern is If my radius server is down, how will the users in that particular realm authenticate? Can i configure a backup/secondary LDAP authentication in that same realm where the radius is primary or the users need to manually change the REALM before connection?
  • @shiprasahu93 we are asking about the SSL connection generated on port 443. Is there any way we can measure this count in real-time.
  • Hi @shiprasahu93 Is any other solution is available. This issue we start facing only after upgrading windows 10 to server 2004 version. We don't want to make any changes at the system level.
  • Hi @Saravanan What if we using analyzer 8.5..?? Are we need to go with the analytics or any other option is available..??
  • Hi @Lucas Did you get the solution on it from support..?? Because same kind of issue i am facing at customer site. Tried everything but file will not get transferred through winscp but when we check same setting going through cyberoam firewall it works fine.
  • @Saravanan So is it advisable to install this version or we should wait for its release.
    in GMS 9.3 Comment by Darshil October 2020
  • Hi @shiprasahu93 By doing this can I able to access google.com..??
  • Hi @Saravanan , What necessary action we need to take to resolve this issue