Can't enable https user login on x0

CGracheff

Has anyone run into this? TZ370 running 7.0.0-r906. I am trying to enable https user login on the x0 IP and attached is the error I receive. I am not changing the zone at all, just toggling the https user login.

shiprasahu93

Hello @CGracheff,

Welcome to the SonicWall Community.

I tested this on the firmware 7.0.1-R1262 and could enable it with no issues. Could you please upgrade to this version and then test it again?

Thanks!

Saravanan

Hi @CGRACHEFF,

Thank you for visiting SonicWall Community.

This seems to be an issue on the firmware version 7.0.0-R906. I have tested this on a TZ 370 running on 7.0.1-R1262 and there is no error displayed when I perform the HTTPS user login enable on X0 interface.

This specific 7.0.1-R1262 firmware is available on the MySonicWall and I would suggest you to upgrade your firewall to this specific firmware version.

Hope this helps.

Ajishlal

Hi @CGracheff

As per your screenshot, You enabled the "Allow management via HTTP",

Disable the"Allow management via HTTP" and try ( it's not recommended).

For Disable that, Navigate to Device / Settings / Administration --> Management

CGracheff

https://community.sonicwall.com/technology-and-support/discussion/comment/8600#Comment_8600

https://community.sonicwall.com/technology-and-support/discussion/comment/8599#Comment_8599

I have replicated this issue on 7.0.1-R1262 on a TZ570 with a similar configuration when it comes to management and user login.

https://community.sonicwall.com/technology-and-support/discussion/comment/8603#Comment_8603

"Allow management via HTTP" is currently disabled.

Ajishlal

Hi @CGracheff

Then how the HTTP management interface came in your screenshot? without enabling the "Allow management via HTTP", it will not show that icon in interface feature.