Comments
-
The problem is that the SSD has 940G remaining capacity, but it does not use it, and only uses 1GB for logs.
-
Yes. I tried saveral times after factory reset on 5080. And this sypmtom has occurred not only TZ but NSA.
-
The reason for port mirror is to introduce NAC equipment. Do you know a product called "Forescout"? We are setting up a port mirror for the introduction of the product. The device is not capturing packets.
-
I did the test in two ways. 1. Dest port 19 / Source 1-16 Result -->> Non packet capture 2. Dest port 16 / Source 1-16 Result --> Packet capture only VLAN113 (VLAN to which the port belongs) Is this bug? or My mistake?
-
@jgrimes Thank you for your interest in my question. I checked the "What is a Stateful High Availability?" you advised. And you said, " On occasion the inactive unit will reboot." But there's no specific mention of what kind of environment the idle unit is rebooting in. Can you tell me what conditions or environments idle…
-
Model is NSA6600, Firmware is 6.5.2.2-44n.
-
HA ports are separate (X6/X7), and these ports are unused. I tried to use it, but I disabled it because I didn't use it.
-
Hi, Please refer to the following, What kind of the interface change are you done? A: The static IP assignment setting of the X5 interface has been changed to disabled. Are you configured Active/Active HA or Active/Passive? A: This is the Active/Standby setting. Did you tried to configure any interface as Portshield Group?…
-
Hello, soon i will upgrade GMS 8.0 to 9.3. So i have one more questions of this upgrade. should I need some license to upgrade GMS 8.0 to 9.3? And also I want to know difference hardware required between 8.0 and 9.3.
-
nope, i sending this information to my customer and i am still waiting for them :(. If i upgrade GMS, i will also update from this page too
-
Thank you so much your response! Its really helpful for me, and maybe ill share this my customer too. Thank you so much again for support Have a nice day for you!
-
Thank you so much your kind response. Can i ask one more questions? Now i understand how can i upgrade 8.1 to 8.7, then how can i upgrade 8.7 to 9.3? And, if I forgot appliance password, should it needs support license and open case right? Thanks, Best regards.
-
Thank you for your help. Ill connect and test that firmware. Have a nice day for you!!
-
Thank you so much your support! can i ask one more question?? what firmware version solve this bug? and also want to know that firmware release day. Have a nice day for you!!