Comments
-
Hi, Is it possible in my SonicWall270 to allow the DHCP lease just for the MAC Address listed devices? (I mean wired LAN) Thanks!
-
to BWC Thanks, didn't notice that I had "restarting is required" warning. After that I got: Primary Stateful HA Licensed Yes Secondary Stateful HA Licensed Yes BTW - when I reboot the primary as it was required - I didn't lost my internet - the second one was Active. So now - I am fine - HA works perfectly -tested it.…
-
Keeping you busy, I'd like to ask regarding the HA. set it up, hope properly, looking on status, I see that "Settings Synchronized: Yes" and "Stateful HA Synchronized: No" Not sure if just to have a wait, or I am done something wrong? Secondly in the HIGH AVAILABILITY LICENCES section I see: Primary Stateful HA Licensed…
-
Thanks Mustafaa, figured thanks u! :-) What about
-
Hi MUSTAFAA, First of all - thanks for the right direction - found, can setup vlans now working on cisco switches connected to my sonicwall. Didn't notice right away - found recently - that I can see from my Vlans other vlans... So could u tell where to look to isolate vilans from accessing from other vlans... Thanks have…
-
Thanks, MUSTAFA, will try. Have a question about buying second Sonicwall, want to get one as a sandbox. Bought one on the E-bay, had to return. It was faulty device, each time when I tried to make a changes - had error message, don't remember exactly - something like "unknown error" , returned, got my money back, Beside it…
-
Hi MUSTAFAA , trying to set it Up don't have a luck yet, guess doing something wrong. To clarify - look the picture pls. I have SonicWall TZ270, CISCO 3750 (L3) switch. Have a several vlans on it. Need to have an access from lets say Vlan1 to Vlan2. The CISCO switch is sitting on X0 There are: Vlan1 - takes IP addresses…
-
Thanks a lot! Will try. In GUI Seems more complicated than just using Cisco commands, hope will get it :-) thanks again!
-
Another question (building the LAN) I have a few CISCO switches (3750 L3 switches) connected to my SonicWall TZ270, can I program in SonicWall route the Cisco vlans? (Know how to do it in CISCO router but not in SonicWall) Thanks.
-
2MUSTAFAA Thanks! Already found why :-) I haven't add the source IP (my sonicwall's IP) into the the Kiwi syslog server (inputs-->receive message from IP) as soon as added - started to get the messages. Thanks anyway! :-)