Bandwidth in site-to-site vpn
Fabin
Newbie ✭
We have two office units. In one unit we have a TZ400 firewall. We are thinking about purchasing a new sonicwall firewall TZ370 in our second ( new ) unit. If we configure site-to-site VPN between our two offices, what is the max bandwidth ( practical values ) that we can get with these devices?
Category: Entry Level Firewalls
0
Answers
depends on:
-speed of your internet pipe at each location
-QoS settings
-amount of users at each location
-security services used at each location/on each firewall
(all of the above come into play for each firewall's load)
I don't think I've tested from a TZ to TZ in a long time, but with 1gbps/1gpbs DIA fiber at all locations, I can do an iperf test and see 300-800mbit/sec between my TZ470s and my NSa2700. The TZ670 often stays on the upper end of that. I have all security services, including DPI-SSL inspection on, although the tests have been done mainly during off-hours so I can get a picture of the potential speeds with an "idle" network. (obviously some stuff is always doing something, but no users/no guest network full of phones and such to muck up the tests)
I will say that in my experience, that TZ400 will be your limiting factor in reaching maximum bandwidth, assuming your internet speeds aren't.
Per the TZ400 spec sheet, 900Mbps is the upper limit for IPsec traffic. If you are inspecting the VPN traffic with other services as well, you can expect lower throughput.