Virtual Interfaces
ECP_Pokerhitman
Newbie ✭
I have recently created a new virtual interface on the Sonicwall and added it to the LAN zone. The interface does not show up as being part of the members for LAN zone. Even if I create a new zone and add the interface to that zone, it doesn't show up as a member.
Also, I am unable to ping the static IP address of that interface even though I have ping selected.
Not sure what check box I am missing to get this to work.
Category: High End Firewalls
0
Answers
@ECP_Pokerhitman what Appliance and Firmware you're running?
I checked on a TZ 570 and NSa 2650 and the interfaces were shown properly in the Zones list:
About the ping, please check LAN-LAN Access Rules if there is a Ping Management Rule which allows the traffic.
I tested the ping on a NSa 2650 from within X0 to X6:V33 IP and got a reply.
You might crank up a Packet Monitor to see if the packets get dropped.
--Michael@BWC
@BWC It is a NSA 2700 and firmware SonicOS 7.0.1-5119-R4713.
That is what I see when I look.
-James @ECP_Pokerhitman
@ECP_Pokerhitman this looks broken, indeed. You might raise a ticket for this, first check with a different browser (Firefox preferred) to rule that out.
I tested on my TZ 670 running -5119, and it got shown properly
Do you have VLAN 55 assigned anywhere?
--Michael@BWC
@BWC VLAN55 is assigned to the LAN Zone
@ECP_Pokerhitman I bound up to 8 VLANs to the LAN Zone on X0 and they all showed up in the Zones listing.
Did you tried a different browser of Incognito Mode to avoid any caching issues?
Otherwise you have to open a Support Ticket for that.
--Michael@BWC
@BWC I have tried Chrome and Edge InPrivate mode.
I have an open Support Ticket with SonicWall.
I even tried to move the V2 and V125 to different zones and they still don't show up as being part of the member interfaces.
I appreciate you working on this with me.
@BWC I found out that because I am using the web configuration that I need to commit and deploy the settings.
The web configuration is new for me.
After deploying and committing the changes everything is now showing up.
Again I appreciate your assistance.
@ECP_Pokerhitman did you do the changes on CLI? This would need a commit indeed.
--Michael@BWC