Block Access from specific Public IP
davidmdlp85 Newbie ✭
How can I block access from specific public IPs, without getting the "From Zone: Rule blocks management rule(s)" error ?
I want to limit the FW login to just certain Public IPs.
Category: Entry Level Firewalls
Hey! You will be signed out in 60 seconds due to inactivity. Click here to continue using the site.
Change the default HTTPS Management rule from allowing Source 'Any' to the IP address you want to allow.
Thanks for your answer.
Is there any way to do the same in the opposite way ? allowing all and denying specific IPs?
The final goal is set the allowed address from an address group configured with FQDN instead IPs
I'm not sure NMS will allow you to do that, but you can try being as specific as possible in the your rule creation. From your screenshot you are not being very specific.
The problem here is that management rules can only be manipulated so much. Either they are enabled on the interface page or not, and from there you can only change certain parameters on the actual access rule. You can't disable it on the interface and create a manual access rule to 'access' it, it doesn't work that way.