NSA 4600 Nat questions
I am new to Sonicwall and one of our application host partners has a vpn set up so they can pull data as needed to host their wholesale store, now they need to print to a printer on our local LAN. they have to ask me to set up a NAT so they can print from their server. they gave me the IP address they are using to print as 10.248.238.11 and our local LAN Printer address is 10.0.0.10
my first shot at this did not work, what did i do wrong, and am i completely off....
NAT Policy for printer
Original Source: Any
Translated Source: Original
Original Destination: PrinterWan address
Translated Destination: PrinterLAN address
Original Service: Any
Translated Service: Original
Inbound Interface: Any
Outbound Interface: Any
IP version: IPv4 ONLY
Definitions:
PrinterWAN: Zone Assignment WAN IP address 10.248.238.11
PrinterLAN: Zone Assignment LAN IP address: 10.0.0.10
Thank you for your time.
Answers
Please provide more details about your config including VPN tunnel information.
what is the best way to get you that data? export the confit?
A quick description of IP subnets used on each end of the VPN tunnel is a good start. Sanitize any confidential information of course.
Have you reviewed the information here: https://www.sonicwall.com/support/knowledge-base/how-can-i-configure-nat-over-vpn-in-a-site-to-site-vpn/170515155805172/
i exported this and cleaned up the ip address and names.
Sorry, im not going to go through 35000 lines of a tech support report when you can describe the VPN tunnel config to us.
Sorry, i will trim it down. to what you asked for.