Menu

Join the Conversation

To sign in, use your existing MySonicWall account. To create a free MySonicWall account click "Register".

Sign In Register

Unable to config physical and logical on Interface probing on TZ570

lgfamisanlgfamisan Newbie ✭
in Entry Level Firewalls

We would like to inquire about the issue where we are unable to configure physical and logical probing on interface probing under failover and load balancing (LB) on the network section. Previously, we were able to access and configure it, but now we can't. Is it possible that this function was disabled due to the new firmware?

sonicwall.jpg

Our firmware now is SonicOS 7.1.2-7019

Category: Entry Level Firewalls
Reply

Best Answer

  • CORRECT ANSWER
    BWCBWC Cybersecurity Overlord ✭✭✭
    Answer ✓

    @lgfamisan go into the settings of your "Defaulf LB Group" and check the tab Probing. If "Probe responder.global.sonicwall.com on all interfaces in this group" is enabled you cannot check per Interface and the option is greyed out.

    Just disable that option and do your probing per Interface like you always did.

    —Michael@BWC

Answers

Sign In or Register to comment.