Error occurred during configuring site-to-site VPN tunnel with Checkpoint firewall
CharithDhananjaya
Newbie ✭
When attempting to configure a site-to-site VPN tunnel between a SonicWall firewall and a Check Point firewall using IKEv2 mode, the Check Point firewall displays the tunnel as "active," while the SonicWall firewall indicates that the tunnel is down. The attached screenshot shows the relevant logs from the SonicWall firewall. There is no communication between the local and remote networks.
Why does only one firewall indicate the tunnel as active, and what steps can be taken to resolve this issue?
Category: Entry Level Firewalls
0
Answers
review the configuration you have put in place on each device.
Check your IKE ID. You will need to set them manually because you're using NAT.
As to why it says Active, that's a Checkpoint question. Perhaps "Active" just means "Not disabled".