TZ 215 export question

mrshahin

Hi

I have an old TZ 125 and I would like to replace this with a NSA2600

The current Firmware of TZ125 is 5.9.1.6-50 and the NSA 2600 is at 6.5.1.1-42n

What should be the TZ 125 firmware version to export the config and import it on the NSA 2600?

Thanks

shiprasahu93

Hello @mrshahin,

Based on support matrix, settings import from a TZ 215 is not supported to a NSA 2600.

https://www.sonicwall.com/support/knowledge-base/can-settings-be-exported-imported-from-one-sonicwall-to-another-support-matrix/170505258332789/

It would be best to build the configuration on the NSA 2600 from scratch.

You can upgrade the firmware on the NSA 2600 to 6.5.1.5 (General release branch) or 6.5.4.6 (latest maintenance release) and then start the configuration.

Thanks!

Saravanan

Hi @mrshahin,

Welcome to SonicWall Community.

A small correction, you are talking about TZ 215 device model and there is no TZ 125 model.

You can make sure the TZ 215 runs on 5.9.1.13 version. But unfortunately the settings from TZ 215 model cannot be migrated to NSA 2600 as per our SonicWall Support Matrix.

https://www.sonicwall.com/support/knowledge-base/can-settings-be-exported-imported-from-one-sonicwall-to-another-support-matrix/170505258332789/

The best practice is to configure the NSA 2600 from scratch for best device performance. You can take self help from our KB portal below for any configuration articles.

https://www.sonicwall.com/support/

Hope this helps.