transfert interface

DSimard

Good morning,

we are in the process of transforming our network from 1gb to 10gb currently everything is on a x4 to 1gb and I have to transfer to a x24 in 10gb. I did some non-conclusive test, that is to say delete my old interface, redo it on the x24 while keeping the same zone, but I believe that the rules do not follow. I wonder if there is a good way to do the transfer of my interfaces. I have 40 to do. tks

BWC

@DSimard to swap the Interface it's pretty straight forward, set X4 to unassigned and configure X24 with Zone and IP address.

BUT it might get tricky, check Routing, NAT and Access Rules before doing this to see if any Rules are bound to X4, you would need to recreate them.

--Michael@BWC

DSimard

My firewall is a NS4650.

DSimard

@BWC tks for your answer.