Join the Conversation

To sign in, use your existing MySonicWall account. To create a free MySonicWall account click "Register".

Tz570 cannot ping devices

ii have a Tz570 where X0 is the LAN and X3 is also the lan zone. I want to ping devices from x0 to devices that are on x3 but i keep getting RTO. where can I look or verify the config

Category: Entry Level Firewalls


  • MustafaAMustafaA SonicWall Employee

    @Ron_DDC , make sure the Access Rule (Allow) for LAN to LAN is in place.

  • Ron_DDCRon_DDC Newbie ✭

    what is the service for the allow rule? Will this also allow the computers on the 25 subnet to ping their gateway 25.1?

  • Ron_DDCRon_DDC Newbie ✭

    Also, can you point me in the correct direction for how to create ACL rules and NAT rules?

  • Ron_DDCRon_DDC Newbie ✭

    I see about the Deny rule but I cant figure out how to open up all devices on a zone called M_Wif to LAN and ip address of

    The Source is x3 and the LAN is on x0

    In other words I have devices 192.168.50.x on x3 on a zone that I called M_WIF and I have a printer on the LAN zone.

    I want to allow devices from M_WIF to be able to print and ping the printer

    Please help.

  • MustafaAMustafaA SonicWall Employee

    You need create an Access Rule with Allow.


    Zone/Interface: M_WIF

    Address: Address Object for, type network

    Port/Services: "any"


    Zone/Interface: LAN

    Address: Address Object for, type Host

    Port/Services: "any" or you can narrow down to the ports used for printing.

  • Ron_DDCRon_DDC Newbie ✭

    I set up as instructed and opened a ping to the printer and still getting a request timed out :(

Sign In or Register to comment.