NSA 2650 System status LEDs
Terminal_2312
Newbie ✭
in MySonicWall
Hi, does anyone know what's wrong with my NSA 2650 sonicwall firewall device? The system status LED is blinking yellow light, as shown below.
Thanks.😀
Category: MySonicWall
0
Answers
@Terminal_2312 is the appliance working as expected? Is it a HA deployment, if HA it might be the heartbeat shown on the standby unit? I checked with a running NSa 2650 and the wrench is off.
The official description is listed below, I kid you not, its the official link provided from SNWL:
--Michael@BWC
@BWC I have read the nsa 2650 firewall manual. Do you think the Wrench LED is blinking amber, slow or fast?
as shown in this short video
https://www.youtube.com/watch?v=rubbkvosND4
the manual says, slow for safe mode and rapid for shutdown.
thank you.
@Terminal_2312 I would say that it is blinking slow ... how about my questions?
Is the appliance working as expected? Is it a HA deployment, if HA it might be the heartbeat shown on the standby unit? I checked with a running NSa 2650 and the wrench is off.
If there is nothing obvious in the log which explains some kind of hardware error, or maybe a broken storage module you might open a case for that, if everything is working as epxected and no HA, which I don't know atm.
--Michael@BWC
@BWC The device is not working normally, when i connect to port X0 or X1, there is no allocation for default ip address (192.168.168.168).
from 2018 to 2021 it functions normally. there is an ip address allocated and I can access the configuration page.
@Terminal_2312 did you tried the MGMT Port with the Default address or 192.168.1.254? If the appliance is not working it might be in safe mode (accessible with 192.168.168.168 on X0 or 192.168.1.254 on MGMT). Serial Console might be helpful as well.
You might be facing this issue:
I guess it's time to call support to resolve.
--Michael@BWC