Menu

Join the Conversation

To sign in, use your existing MySonicWall account. To create a free MySonicWall account click "Register".

Sign In Register

NSa 4700 - HA Secondary (Active) Interface Status incorrect

BWCBWC Cybersecurity Overlord ✭✭✭
in Mid Range Firewalls

Hi,

I'am deploying two NSa 4700 (7.0.1-5080) at the moment and the Secondary Firewall does not show the correct State of the Interface Ports at Home -> Dashboard -> System -> Device. The graphical presentation shows 6 out of 15 actively used Interfaces as up (green). If I head over to Network -> System -> Interfaces all Interfaces showing that they are up with 1 Gbps.

The Primary Unit is displaying the correct State of the Ports.

It's just an UI glitch, was this already known and reported?

--Michael@BWC

Category: Mid Range Firewalls
Reply

Best Answer

  • CORRECT ANSWER
    BWCBWC Cybersecurity Overlord ✭✭✭
    Answer ✓

    Nevermind, the Secondary Unit was running on an older Firmware for an unknown reason, I'am sure that I did the sync, but it seems that it was not working and I wasn't paying attention.

    After a while the Secondary Unit freaked out and booted into Safe Mode by it's own, this was the moment when I realized the Firmware differs.

    With the Firmware in sync on both Units, it looks like everything is back to fine now.

    --Michael@BWC

Sign In or Register to comment.