Need assistance about DHCP server
tejasshenai
Newbie ✭
I have enable DHCP on my SonicWall.It works fine but now I want to allow DHCP service for only allowed port on firewall or switch.
e.g. If i have allowed first 4 port of firewall or switch then they should be assigned ip from dhcp and if i used any port other than that then the device shouldn't get up.
Is this configuration possible? If yes how to achieve that.
Thanks.!
e.g. If i have allowed first 4 port of firewall or switch then they should be assigned ip from dhcp and if i used any port other than that then the device shouldn't get up.
Is this configuration possible? If yes how to achieve that.
Thanks.!
Category: Entry Level Firewalls
0
Answers
@tejasshenai did you assigned all the ports to the same PortShield Group? Then the answer would be no, because it's a simple bridge group and all ports are equal.
You have to create another PortShield Group (or single interfaces) with different subnets, depending on your requirement.
--Michael@BWC
Ok thanks. Will check that.