Sonicwave READ-ONLY mode
Hi. I am trying to setup a sonicwave 231c in standalone mode. The access point has ip and I can enter its
management, but only in READ-ONLY mode. Hi. I am trying to setup a sonicwave 231c in standalone mode. The access point has IP and I can enter its management, but only in READ-ONLY mode.
On one occasion I remember having ssh entered the AP and with some command that I do not remember I was able to change it. Do you know that command?
Thanks a lot
Best Answers
-
OptionsCORRECT ANSWERshiprasahu93 Moderator
Hello @Edu,
Welcome to SonicWall community.
Once you are in Read-Only mode on GUI, SSH to the device and then enter the following command "enableRadioCfg" and then exit out of SSH. Then refresh the GUI and then you will be able to make changes.
I hope this helps!
Thanks!
Shipra Sahu
Technical Support Advisor, Premier Services
6 -
OptionsCORRECT ANSWEREdu Newbie ✭
I answer myself. I already found the solution. Running the enableRadiocfg command.
0
Answers
Perfect. Glad that it all worked out.
Shipra Sahu
Technical Support Advisor, Premier Services