SNMP v2 no response
pipi_delina Newbie ✭
edited October 2020 in High End Firewalls
I have a multi VLAN environment and I am trying to use SNMP to monitor my sonicwall, but it briefly works and stops working altogether. I installed Cacti RRD tool to poll and plot graphs but the SNMP seem not to be working just.
I am assuming that the issue under this thread could be similar to what am facing although they are not the same.
Attached are the sample config I did on the firewall.... in case you are wondering its NSA6600
Category: High End Firewalls
Hey! You will be signed out in 60 seconds due to inactivity. Click here to continue using the site.
Welcome to SonicWall community.
I would suggest trying the steps given in the KB below
Otherwise, while the SNMP probes are being ignored, please set up a packet capture on the firewall and see if they are being dropped due to a false alarm as a flood or something similar.
I hope that helps!
Technical Support Advisor, Premier Services