Arkwright All-Knowing Sage ✭✭✭✭
Reactions
-
Re: How do I route remote VPN device through default gateway with NAT like SSLVPN
The above could work but you would end up with everything in the 192.168.3.0 network using it. If you want more fine-grained control over who uses the site-site as a default route, then you need a tu… (View Post)1 -
Re: How can I connect a Mikrotik router to a Sonicwall firewall TZ370 and gain internet access?
By default on smaller Routerboard, ether1 is a DHCP client. So you could just plug that straight in to X3 of your Sonicwall. How you configure X3 next is up to you. You could either add it to portshi… (View Post)1 -
Re: WAN (IPv6) <-> LAN(IPv4)?
If your provider won't change the WAN-side addressing, then you will either have to change your LAN side addressing or change provider. If you absolutely must use this provider and use 192.168.1.0/24… (View Post)1 -
Re: Cannot Translate Multiple Ports To A Single Host
If your error isn't really about the port numbers [I cannot believe the firewall will let you add TCP port 99999 as a service] then it's something else about the policies that overlaps. Post some act… (View Post)1 -
Re: Audit Log Export to Syslog
Check "Enhanced audit logging" setting on Management page. You can generate extra log entries with this setting [NOT in the Audit Log section] and this is off by default. (View Post)1