Comments
-
@BWC Yes put in the DG for testing to see if this made a difference. I'll remove this after testing as this wasn't in originally. DHCP is configured correctly. The original Guest WIFI works fin with no issues - I have just tested the original now and there are no issues. Only the POC has the Default Gateway ARP issue.…
-
@BWC Yes 10.32.40.10 is the VLAN INT on the SNWL for the Guest WIFI and Yes ping is enabled please see below. DHCP Scope for this subnet is also the same. I'm going around in circles a bit as I cannot seem to work out why the Default Gateway would not work for what is essentially the same subnet and settings. Thanks,
-
@BWC - Thanks Michael, I can see this and will do the necessary. Kind Regards, Asif
-
@BWC - thanks Michael, can you point me to where I find this option in the My SonicWall portal please? Thanks, Asif
-
@BWC and everyone else. The upgrade is complete and working. I registered the devices only at this stage. Do I need to transfer and licences from the old NSa 4650 to the new NSa 4700 devices? Kind Regards, Asif
-
@BWC - thanks Michael. appreciate your response to this. I'll be swapping the units out on Monday so I'll post back on here. Kind Regards, Asif
-
Has anyone any comments on the procedure above - even to say yes this is OK?? Thanks, Asif
-
Hello Everyone, I believe I am now in a position to start making the changes to the new NSa 4700 firewalls. What I have done so far is: Registered the 2x NSa 4700 in My SonicWall as a Primary and Secondary unit as Register only. Associated the Primary unit with the Secondary using HA association. Updated the firmware on…
-
@BWC - Hi Michael, I've started a trial of the Management and Analytics Services on the NSa4700 and this has made the Managed by Cloud and Zero Touch options available. Many Thanks, Asif
-
@BWC - Hi Michael, I will be transferring our existing licences across to the new NSa4700 when the NSa4700 is ready for this. The current licences support cloud management if that is what you are asking. Thanks, Asif
-
Hello, I have registered the product and completed a Firmware upgrade. Unfortunately, I chose the On Box option for management and need to change this to cloud. In the NSa 4650 there is an option to change this using the SN. I can't see this on the new NSa 4700. Is there a way to change the Managed By to Cloud? Thanks, Asif
-
@BWC - thanks Michael. The simpler the better in my book. I'll let all of you know how I get on with this. Thanks, Asif
-
@BWC - thanks Michael, so in essence patch both the MGMT and X1 port to the network for LAN and WAN access? Thanks, Asif
-
@BWC - thanks Michael. 192.168.1.x/24 is not a range we use, X1 as DHCP would be the best option. Is it a simple case of accessing the IP assigned via DHCP through a web browser? Thanks, Asif
-
@BWC - Thanks Michael, the new device is just out of the box with no or the default config from the factory. No IP assigned yet. I trust I can add this to the network for firmware upgrade/registration etc. before importing the config? Thanks, Asif