GVPN Client cannot operate in Split Tunnel mode if SSL VPN is operating in Tunnel All mode
DavidHelpTech Newbie ✭
in SSL VPN
GVPN Client cannot operate in Split Tunnel mode if SSL VPN is operating in Tunnel All mode, I spoke to SW Support and our workaround was to configure GVC as Tunnel All mode, it would be nice if we could have the option of either though as users in our organization do not need Tunnel All mode at all times. Note when Tunnel All is setup on SSL VPN the GVPN in Split Tunnel mode will only let you reach Remote LAN resources, however the metric is set to 2 on my Windows 10 PC and therefor I cannot access the internet, the GVC intercepts the traffic but is not permitted to send it through the gateway.
Category: SSL VPN
Hey! You will be signed out in 60 seconds due to inactivity. Click here to continue using the site.
did you use same ip subnet block for ssl-vpn settings and gvc vpn settings?
No, our GVC VPN pulls IP's via DHCP Relay pointed at the Windows domain controller on the 192.168.113.0/24 subnet, and the SSL VPN IP Pool is a 172.16.60.1-172.16.60.49 range within the SonicWALL, the usual / only method that I know of.
could you create diffirent sub-interface and ZONE for GVC. you don't use VPN zone for GVC and try split vpn settings.