SONICWALL TZ670 DMZ NAT NOT WORKING
dansoa22
Newbie ✭
Hello,
I have a SonicWALL TZ670 with the below configuration:
WAN IP (X1 Interface) : address 67.x.x.98
The LAN zone on the X0 port is 192.168.20.1
DMZ on X6 Port is 192.168.40.1
The Web server that we want to put in a DMZ is directly plugged into the X6 port and has a static IP address 192.168.40.50 with a Default Gateway of 192.168.0.1
How can I create an access rule and NAT for DMZ to WAN and WAN to DMZ?
Also, How can I create an access rule and NAT for DMZ to Access a specific server via HTTPS port only for an application server on my LAN with IP address of 192.168.20.90. Am fairly new to Firewall NAT and Access rules configuration so any help will be very much appreciated.
Regards
Gloria
Category: Entry Level Firewalls
0
Answers
@dansoa22 shouldn't be the default gw address of your web server 192.168.40.1, because 192.168.0.1 is not part of your X6 subnet.
If you're not familiar with that product I suggest you start with the Basics, taking a course or hiring someone.
You should tcheck he Knowledge Base for that kind of Firewall 101 questions. This might be worth looking into.
https://www.sonicwall.com/support/knowledge-base/how-can-i-enable-port-forwarding-and-allow-access-to-a-server-through-the-sonicwall/170503477349850/
--Michael@BWC
@BWC Many thanks for pointing that out. My DG is actually actually set as 192.168.40.1.
192.168.0.1 was just a typo error. I have also used the port forwarding help in the Knowledge base but still couldn't get it to work hence the post.