How to Edit Or Delete Auto Added Access Rule

dan_ss · August 2021

I'm on firmware 7.01 using a TZ270. Followed this guide:

https://www.sonicwall.com/support/knowledge-base/how-to-edit-or-delete-auto-added-access-rule-s-and-nat-policies/170502578285909/

but it just forces an auto-log out to: dynLoggedOut.html

Is there another way to edit access rules since v7 firmware?

preston · August 2021

Hi @dan_ss , just put diag after the m/

like https://192.168.168.168/sonicui/7/m/diag

just replacing with your IP and port number if different to the default

Saravanan · August 2021

Hi @DAN_SS,

The diag page access should work in Gen 7. I tested this out on a TZ 370 appliance.

Please login to the Gen 7 box and change the URL to https://IPaddress/sonicui/7/m/mgmt/settings/diag

You will land into the diag settings page.

Hope this helps.

dan_ss · August 2021

I also tried this method

https://community.sonicwall.com/technology-and-support/discussion/2568/enable-the-ability-to-remove-oder-edit-auto-added-rule-sonicos-7

but manually altering the url to apend diag forces a logout too.

dan_ss · August 2021

Thanks @preston and @Saravanan I'm sorted now. I was incorrectly adding diag after system: https://ipadress/sonicui/7/m/mgmt/system/diag which was my probem.

Both these do indeed work: https://ipadress/sonicui/7/m/diag and https://ipadress/sonicui/7/m/mgmt/settings/diag

Saravanan · August 2021

Glad to hear that you were able to perform @dan_ss.

Wolf · August 18

Hi,

this is A TZ370 with SonicOS 7.1.2-7019. I cannot find the specific setting. I need to remove auto added access rules in order to remove a virtual interface.

Join the Conversation

How to Edit Or Delete Auto Added Access Rule

Best Answers

Answers