Join the Conversation

To sign in, use your existing MySonicWall account. To create a free MySonicWall account click "Register".

Cannot create an Access Rule policy with a Address Group

Hello,

I've got a new TZ570 and I'm trying to create an Access Rule policy with the following parameters:

SOURCE:

Zone/Interface: WAN

Address: TrunkGroup --> This is a group of Address objects. All of them are IPv4 addresses

Port/Services: Any

DESTINATION:

Zone/Interface: LAN

Address: D01 Public --> This is also an IPv4 address

Port/Services: SIP

When I do this, I get the following error:

"Source address and destination address cannot be of different IP versions"


If I add one of the addresses in the group, it works fine.


Please help to resolve this issue.

Category: Entry Level Firewalls
Reply

Comments

  • prestonpreston Enthusiast ✭✭
    @PeterM , I've had this before on gen6 appliances, add the rule with one address in the group,
    then go to objects/address object groups edit the address object group under and add the rest of the IPs in, just check if the rule is still there after a reboot as when I had this issue I had to get a hot fix from support
  • Hi @PETERM,

    Thank you for visiting SonicWall Community.

    We are already aware of this issue and the same is fixed on the Gen 7 firmware version 7.0.0-R464 and above. Please upgrade your firewall to this firmware version.

    Hope this helps.

    Regards

    Saravanan V

    Technical Support Advisor - Premier Services

    Professional Services

Sign In or Register to comment.