Failover an Load Balancig Issue after upgrate to 7.0.1-5023-R1826 on Tz-570
Good evening, after updating to the indicated version I have a problem in managing failover and load blancing. If I try to change the order of interfaces from x1 to x2 as primary I get this message: Error Enter a valid IPV4 address for default target in X1. Same thing if I try to change any other parameter in the interface probe settings. It would be possible to boot from the previous firmware. I uploaded the penultimate version 7.0.1-5018-R1709. Thanks in advance
Category: Entry Level Firewalls
Hey! You will be signed out in 60 seconds due to inactivity. Click here to continue using the site.