Routing between VPNs at multiple sites
vpnsrus
Newbie ✭
I have a TZ400 at the main office, and we have 2 satelite offices connected over IPSec VPNs.
I want to be able to reach Satelite A from Satelite B going through the main office router, but cannot seem to figure out the correct settings on the TZ400. SonicOS 6.5.
PCs at A cannot see devices at B and vice versa. I have tried creating static routes but cannot figure out if this is adnaved networking, NAT, routing policy, etc.
Here are the networks:
Main - 192.68.202.0/24
Site A: 192.168.203.0/24
Site B: 172.18.0.0/16 (not sonciwall)
Thanks for any help
Category: Entry Level Firewalls
Tagged:
0
Answers
Are you using policy or tunnel based VPN's?
Either way it should work but the requirements differ a bit. My immediate guess is that you don't have a VPN -> VPN rule at the Main site.
Hello @vpnsrus,
This implementation is called the hub and spoke setup. You can refer to the KB below and make sure that the configuration is done correctly.
I would like to add that the routes are only necessary if you are using tunnel interface VPN and not site to site VPN.
Thanks!
Shipra Sahu
Technical Support Advisor, Premier Services